In diesel fuel systems, the fuel provides lubrication for the fuel pump and injectors. A fuel with poor lubricity can cause excessive wear and premature failure of these components. Improve lubricity and extend engine life.

Diesel fuels have pour points (the lowest temperature at which an oil or other liquid will pour under given conditions) within the range of normal winter temperatures. As a fuel approaches its pour point, paraffin in the fuel form wax crystals that prevent it from flowing. Flow-improver additives modify the wax crystals, lowering the pour point of the fuel and give better cold weather performance.

For on-sight storage tanks other issues must be looked at. On-sight storage tanks always have a small amount of the first gallon of fuel ever put in them, unless it is drained 100% and cleaned. So adding new, fresh fuel always has a bit of the bad added to it every time fuel is purchased. Diluting the bad with good over time is a loosing battle. The fuel will always be bad fuel until the core problem is addressed

The order of treatment for fuel related problems should always begin with a determination of whether there is water in the fuel and if the fuel has microbes (fuel bugs) in it. Water Paste and Fuel Test Kits can be used for this stage of maintenance. If microbes are detected, then the use of biocides is needed. Biocides have no effect on and will not eliminate the sludge problem. Biocides kill bacteria, that's all!

The water issue should always be remedied first by the use of fuel water separators on the tank or on the equipment. Next a multifunctional chemical additive should be added to improve fuel performance and then if needed a problem specific additive to dissolve diesel sludge and or a rust inhibitor to protect steel tanks. For long-term prevention, the use of magnet fuel conditioners is recommended. These devices continually reverse the re-polymerization of the fuel during circulation and reduce the need for ongoing additive use. All the needed cures are available from Dieselcraft Fluid Engineering at www.dieselcraft.com