Heatec makes, sells and services a broad line of heaters, liquid storage tanks and related products. Our products are used mostly at facilities of producers and manufacturers in their production operations. Key users are hot-mix asphalt (HMA) plants, asphalt terminals, emulsion terminals and concrete producers. Other key users include oil and gas producers, chemical producers, food producers, roofing manufacturers, power plants, etc.
Heatec displayed a new emulsion mill skid at CONEXPO–CON/AGG 2014. Included on the skid are an asphalt meter system, a latex pump, a control panel, and the new Barracuda™ colloid mill.
Skid is designed to produce 60 tph of emulsified...
Heatec metering system widely used at HMA drum mix plants. Heatec calibration tank for HMA drum mix plants.
Known as "a pump pushing a pump"
Can be calibrated to an accuracy of plus or minus one-tenth of one percent (0.1 percent)
Heatec asphalt emulsion tank at a HMA plant.
Electrically heated, also available with hot oil heating
Available with or without insulation
Available in a variety of capacities
Available with or without mixers
Includes load out system
Heatec 20,000 gal. fuel tank at a HMA plant.
Available in capacities ranging up to 25,000 gal.
Available in a variety of configurations: vertical, horizontal, skid-mounted, portable, with or without double containment
Vertical tanks meet the...
Heatec Heli-Tank unit for portable HMA plants.
Includes a thermal fluid heater, unloading pump, metering system, and storage tank on a trailer-type chassis
Storage tank can have separate compartments for asphalt and fuel
The heater heats the...
Heatec vertical tanks at a HMA plant. Four are asphalt tanks (ivory) and two are fuel tanks (brown). The asphalt tanks have a capacity of 20,000 gallons each. One fuel tank stores 13,000 gallons and the other stores 20,000 gallons.
Heatec Firestorm direct contact water heater, rated at 6 million Btu/hour.
Available with outputs ranging from 0.75 to 36 million Btu/ hour
Heats water on demand, providing a continuous supply of hot water at a constant temperature
Heatec booster heater at an asphalt terminal.
It is used to increase temperature of asphalt on demand as it is pumped through the heater coil to loading racks and into awaiting tankers
It boosts temperatures up to 80 degrees F above its inlet...
Heatec expansion tank and pump skid at an asphalt terminal.
The single expansion tank here is used for the thermal fluid system, including a backup heater
The tank and pumps are remotely located outside of the building where the heaters are...
Heatec HC helical coil heater for heating thermal fluid at HMA plants. Larger heaters are available for terminals.
A single heater can heat thermal fluid circulating in one or more circuits that heat multiple pieces of equipment
Heatec polymer blending system is one of the many polymer systems the company has provided for terminals in the U.S. and overseas.
Available in both fixed and portable configurations
Company was an early pioneer in producing systems to...
Heatec portable calibration tanks are used to calibrate the liquid asphalt metering system of a drum mix asphalt tank.
Can run three cycles with the calibration tank in less time than it takes for one cycle with a distributor truck
Load cells are...
Heatec is heavily involved in building new asphalt storage terminals and asphalt emulsion plants. The Rockmart terminal shown here is a showcase for Heatec’s terminal work. Terminal equipment may include:
A tank-car and barge unloading...