PE1000+ is a two-component, high-strength adhesive anchoring system designed for bonding threaded rod and reinforcing bar hardware into drilled holes in concrete and solid masonry base...
AC50 Silver is a two-component, quick-cure, vinylester adhesive anchoring system designed for bonding threaded rod and reinforcing bar hardware into drilled holes in solid concrete base materials...
Pure 50+ Epoxy is a two-part, 1:1 epoxy adhesive anchoring system for use with guard rails, doweling, road lighting, rail systems and signage.
Designed with concrete contractors and road...
The Smart DI+ from Powers Fasteners is an all steel internally threaded anchor designed to reduce the amount of force required to set the anchor. What used to take approximately 20 hammer blows on a...
The new C-5 Trak-It from Powers Fasteners is a gas fastening system that can shoot 1/2- to 1-1/2-in. pins in diameters of .102, .120 and .145 in a variety of base materials, including concrete. The...
Powers Fasteners' Power-Stud+ SD1 Wedge Anchor is now ICC-ES code listed for cracked and uncracked concrete. The Power-Stud+ SD1 is a fully threaded, torque-controlled wedge expansion anchor. Suitable...
Two-component, high-strength structural adhesive anchoring system meets IBC for strength design of concrete anchors Can be used to bond threaded rod and reinforcing bar into solid concrete and...
ICC-ES approved for strength design, aka cracked concrete Install by setting into a drilled hole and then tightening with a ½ impact wrench until flush with the ceiling and ready for the insertion...
Powers Fasteners introduces its all-steel Lok-Bolt AS mechanical sleeve anchor. The new design eliminates the product from getting hung up in vertical holes. And its collapsible, all-steel...
Powers Fasteners' Tapper and Screw Anchor has a new thread desing and lower torque. This line of screw anchors can handle most light to medium duty fastening applications in concrete, block and...
One-piece fully threaded, wedge anchor Designed for cracked concrete and other masonry applications Available in 3/8-, 1/2-, 5/8-, and 3/4-in. diameters
Has a larger combustion chamber and a modified valve design
Fires 2 9/16 pins through 2x4s into concrete and steel base materials
42-pin magazine capacity
Utilizes a pezio to fire the tool...
