ForConstructionPros.com

Ingersoll Rand MT-2000 Milling Machine
The Ingersoll Rand MT-2000 is a four-track, front-load, half-lane milling machine.

• 600-hp Tier III Cummins engine
• Three distinct drum cutting speeds: standard cutting speed, high-speed selection, and deep-cut power bulge
• Can run both 78.75- and 86-inch drums
• 36-inch-wide gathering and discharge conveyors are independently controlled with variable speed adjustment

Bomag ProTack TW500
The ProTack TW500 tack wagon from Bomag is designed for heating and spraying emulsified asphalt for various projects.

• 12-gpm direct-drive asphalt pump
• 5.5-hp Honda engine
• Primary tank holds 500 gallons and features a 10-inch fill spout
• 50,000 BTU vapor propane burners
• 40-foot-long, 1/2-inch-diameter hose allows operators to spray in an 80-foot work area without moving the base unit
• 6-foot spray wand with replaceable tip
• Heavy-duty trailer frame with two 3,500-pound GVW axles, electric trailer brakes and safety chains

Blastrac 2-4800DH Shot Blaster
For highways, streets and bridges and other large asphalt surfaces, the Blastrac 2-4800DH shot blaster can remove striping and markings on roadways, clean tire rubber, residue and surface contamination and improve skid resistance.

• Travel speeds up to 350 fpm
• Twin centrifugal blast wheels with a 48-inch blast pattern
• Blast head adjusts side-to-side for blasting at any position within the machine width or within 6 inches of an obstruction
• 350-hp diesel engine
• Onboard 3,500-cfm dust collector

Blacklidge Trackless Tack